|

|
HSJL系列蔬菜温室大棚卷帘机产品介绍
随着农村改革开放的不断深入,农业技术的深入推广,大棚种植面积的不断扩大,传统的靠手工操作的大棚卷帘已经越来越不能适用现代化农业的发展,它不仅体力强度大、卷放时间长,而且草帘易损耗,更新周期短,并且不易存放。为了把广大农民朋友从繁重的体力劳动中解脱出来,我厂集中科研人员努力攻关,开发研制出HSJL系列卷帘机,为广大农民朋友发展生产提供了一个好帮手。
HSJL系列卷帘机的开发和研制,为了适应广大农村不同使用情况的特点,电动、手动均可操作,并且在冬季过后,只需把草帘卷到大棚顶部,再蒙上塑料膜加以覆盖、包裹,便可使草帘使用周期延长,并且可节省大量存放草帘所需空间。
|
HSJL系列卷帘机的特点:
1. 适用于长度在100米以内的各种尺寸的钢架结构或水泥结构的塑料大棚。
2. 对于宽度在10米以内的大棚,电动卷帘时间不超过7分钟,当停电或电器部分故障时可用手动装置完成卷帘工作。
3. 适用于各种材料编织的草帘。
4. 安全性好,可靠性高。
5. 能在各种气候条件下使用。
6. 操作简便,按动电钮,上下自如。
7. 安装、保养、维修方便。
8. 投资少、收益高。
HSJL系列卷帘机适应了农村现代化建设的需要,使农民朋友从繁重的体力劳动中解放出来,为农民朋友致富提供了物质条件。
该项产品在1998年全国农机新产品推广会上获得金奖。我们会用稳定的产品质量,优良的售后服务,为广大农民朋友服务。
APPLICATION
The HS Series Chain Block is a portable lifting device
easily operated by hand chain. It is suitable for use
in factories, mines, farms, construction sites, wharves,
docks and warehouses for installation of equipment, as
well as for loading and unloading goods, it is specially
advantageous for lifting work in the open air and places
where no power supply is available.
The chain block can be attached to a trolley of any type
as a traveling chain block, it is suitable to monorail
overhead conveying system, hand traveling crane and jib
crane.
FEATURES
Five prominent features in design and in service are inherent
in HS Series Chain Block :
● Safe reliable in operation with minimum maintenance.
● High efficiency and small handpull
● Light weight and easy handing
● Fine appearance with small size.
● Durability in service
MAINTENANCE
● Clean off the dirt on the chainblock , lubricate its
parts with grease after use and store it in a dry place.
● Maintenance and inspection should be made by a sklled
hand. Neverallow any layman to disassemble or to assemble
the block.
● Align the "0"marks of the two gears (8) while
assembling, as shown in Section View C-C.
● While assembling the brake mechanism, care should be
taken to mesh the slanting teeth of the ratchet disc and
the pawl. Make sure that the spring and pawl work sensitively
and reliably. Then turn the hand wheel clockwise, it must
press the disc and the plates on the brake seat. Turning
it counterclockwise, there should be clearances between
the disc and the plates.
● After cleaning and repairing the block should be subjected
to no-load test and load test. A chain block can be put
into operation after it has been tested and found under
reliable brake and in good condition.
● Keep clean the friction surfaces of the brake. Brake
mechanism should be inspected regularly for prevention
of faulty braking and falling of the load.
|